Frequently Asked Questions

FAQ FAQ ID Sort ascending
What is the difference between the P7513A and P7513?

The difference between these two probes is a longer cable on the P7513A.  The added length


This FAQ applies to:
P7513, P7513A
773521
How do I set up a network drive on my 5 Series MSO or 6 Series MSO?

Introduction


This FAQ applies to:
MSO54, MSO56, MSO58, MSO58LP, MSO64
773296
Tektronix Video Test Signal generators – and future GPS roll-over dates.

In short, the GPS roll-over date will have no effect until possibly 2029, depending on the product. For more detail Download File.

 

 


This FAQ applies to:
SPG8000, SPG8000A, TG700, TG8000
773206
Host ID for SourceXpress or for the optional application plug-ins?

Within SourceXpress, from the Tools menu, click on “Licenses” to display the license management screen.  The Host ID is listed at the top of the screen.


This FAQ applies to:
ENVFL-SS01, ENVNL-SS01, HSSFL-SS01, HSSNL-SS01, MTONEFL-SS01, MTONENL-SS01, OPTICALFL-SS01, OPTICALNL-SS01, PRECOMFL-SS01, PRECOMNL-SS01, RFGENFL-SS01, RFGENNL-SS01
772691
TRCP0300, TRCP0600, TRCP3000 power supply

Tektronix does not offer a replacement part number.


This FAQ applies to:
TRCP0300, TRCP0600, TRCP3000
772586
Kickstart 2.x.x Software License Installation Process

If you ordered KICKSTARTFL-BASE that is used with the Kickstart 2.0 or higher software application.  If you ordered KICKSTARTFL-HRMA that is used with Kickstart 1.9 software application>


This FAQ applies to:
KICKSTARTFL-BASE, KICKSTARTFL-HRMA
772141
Error message “CvP Tester Didn’t Run” on my 5 Series MSO.

Instruments that have both a Linux drive and a Windows drive should have the same firmware revision on both drives.


This FAQ applies to:
MSO54, MSO56, MSO58, MSO64
771991
DMM7510 in 4W RTD outputs a square wave signal that affects Fluke Calibrator during calibration.

The reason there is what appears to be a square wave output when the RTD temperature measurement is turned on is because offset compensation (OCOMP) is enabled by default.

This FAQ applies to:
DMM7510

729751
How to set ACV DB function in Model DMM6500

In the SCPI command set mode, the following commands will get you there:

:SENSE:FUNC 'VOLT:AC'

:VOLT:AC:UNIT DB

:SENSE:VOLT:AC:DET:BAND 300

:SENSE:VOLT:AC:DB:REF 5


This FAQ applies to:
DMM6500
729491
Can two Model 2657A be placed in parallel to gain higher current?

The 2657A can be connected in parallel with another 2657A to double the current available.
Please make sure that the LO is tied to ground when you are connecting the 2657A in parallel to double the current available.

This FAQ applies to:
2657A

729096
Downloads
Download

Download Manuals, Datasheets, Software and more:

Go to top